Jensen MP3 Docking Station JiSS 250i User Manual

Portable Speaker Station for iPod & iPhone  
INSTRUCTION MANUAL  
JiSS-250i  
(iPod & iPhone not included)  
Please read this Instruction Manual carefully before  
using the unit and retain it for future reference  
 
COMPLIANCE WITH FCC REGULATION  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two  
conditions:  
(1) This device may not cause harmful interference, and (2) This device must accept any  
interference received, including interference that may cause undesired operation.  
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential installation. This equipment generates, uses  
and can radiate radio frequency energy and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to try to correct the interference by one or more of the  
following measures:  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment and receiver.  
- Connect the equipment into an outlet on a circuit different from that to which the receiver is  
connected.  
- Consult the dealer or an experienced radio/TV technician for help.  
CAUTION  
Changes or modifications not expressly approved by the party responsible for compliance  
could void the user’s authority to operate the equipment.  
PROTECT YOUR FURNITURE!!  
This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you  
operate the controls. These ‘feet’ are made from non-migrating rubber material specially formulated  
to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture  
polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and leave  
marks or a rubber residue on the furniture.  
To prevent any damage to your furniture we strongly recommend that you purchase small self-  
adhesive felt pads, available at hardware stores and home improvement centers everywhere, and  
apply these pads to the bottom of the rubber ‘feet’ before you place the product on fine wooden  
furniture.  
2
 
LOCATION OF CONTROLS  
1
2
3
4
5
6
1.  
2.  
3.  
4.  
5.  
6
7.  
8.  
9.  
LEFT SPEAKER  
Docking Tray  
Docking Connector  
RIGHT SPEAKER  
STANDBY BUTTON  
VOLUME +/- BUTTON  
AUX IN JACK  
DC IN JACK  
FOLDABLE STAND  
10. BATTERY DOOR  
7
8
9
10  
9
POWER SOURCE  
This Portable Speaker System is designed to operate on 4 x 1.5V ‘AAA’ (UM-4) batteries (Not  
included) or with the included AC Adaptor.  
GETTING STARTED  
A. DC OPERATION  
For better performance and longer operating time, we recommend using alkaline-type batteries.  
1. Remove the battery door on bottom of the cabinet.  
2. Observe the polarity markings inside the compartment and install 4 x 1.5V ‘AAA’ (UM-4)  
batteries correctly.  
3. Replace the battery door.  
.
IMPORTANT: Be sure that the battery is installed correctly. Wrong polarity may damage the unit.  
BATTERY CARE  
I.  
Do not mix old and new batteries.  
II.  
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.  
III. If the unit is not to be used for an extended period of time, remove the battery. Any old or leaking  
battery can cause damage to the unit and may void the warranty.  
IV. Do not dispose batteries in fire. Batteries may leak or explode.  
3
 
B. AC POWER CONNECTION  
1. Plug the AC adaptor into a household 120V AC ~ 60Hz power source.  
2. Insert the other plug into the DC INPUT Jack on the back of JiSS-250i.  
Note: The batteries will be automatically disconnected once the AC adaptor is plugged into the DC  
Jack and the System will operate on AC power.  
iPod ADAPTORS  
Below are the iPod Adaptors included in the package.  
iPod classic  
iPod touch  
iPod Nano 2nd  
Gen.  
iPod nano 3rd  
gen.  
iPod Nano 4th  
Gen.  
iPhone  
Note: No iPod adaptor is needed if you are using an iPod (5th generation) or iPod (4th generation).  
4
 
DOCKING YOUR IPod  
1. Fold out the STANDS located on the bottom of JiSS-250i.  
2. Select a suitable adaptor attachment for your iPod/iPhone and insert it into the docking tray.  
Your iPod/iPhone can now be inserted onto the dock connector by aligning the connector on  
the bottom of the iPod onto the connector in the docking bay as shown below.  
For iPod/iPhone Landscape Viewing (iPod nano (4th gen), iPod touch, iPhone 2G,  
and iPhone 3G) proceed as below:  
3. Choose the Correct adaptor to hold the iPod/iPhone and embed it at the iPod docking tray.  
4. Extend the Speaker by pulling out the Left and Right Speaker  
5. Insert the iPod firmly on the docking, now the iPod can be rotated freely into the Landscape  
position to the Left as shown.  
Note: - Please be careful when seating the iPod/iPhone into the docking to avoid damaging the  
30-pin connector on the iPod or in the docking system.  
-The iPod/iPhone will start charging immediately when it is docked.  
- The iPod/iPhone will only be charged when the device is powered by an AC adaptor.  
6. Turn the JiSS-250i on by pressing the STANDBY Button on the front panel.  
7. Follow the iPod/iPhone operation instructions to operate your iPod/iPhone.  
8. Adjust the sound level by pressing the VOL +/- buttons on the JiSS-250i.  
Note: The volume level cannot be adjusted using the volume control on your iPod after docking.  
9. To remove the iPod/iPhone from the unit, press and hold the PLAY/PAUSE Button for few  
5
 
seconds to switch off the device and then gently remove it from the docking connector.  
10. To turn JiSS-250i off, press the STANDBY Button again.  
Note:  
i.  
The System will automatically enter sleep mode 5 minutes after playback stops and switch to  
standby mode automatically after 30 minutes of no activity. In Sleep mode the LED will flash  
and in standby mode, the LED will go off.  
ii.  
iii.  
The AUX In function is in higher priority than the iPod function. Make sure the AUX IN Jack is  
unplugged when you are going to enjoy the iPod music, otherwise the music of the iPod won’t  
be heard.  
Your iPod/iPhone will only be charged when the System is powered by AC.  
AUX IN OPERATION  
You can play other music sources (MP3 or other digital audio players) through the speakers of this  
System by connecting the AUX IN Jack to your external player’s audio out jack or headphone jack.  
1.  
2.  
To turn the JiSS-250i on, press the STANDBY Button on the front panel.  
Plug one end of an audio cable (included) into the AUX IN Jack and the other end of the cable  
into the headphone jack of your digital audio player.  
3.  
4.  
Start playing the device plugged into the AUX IN jack.  
Adjust both the volume controls on the JiSS-250i and your external player for a comfortable  
listening level.  
5.  
Turn off your external player when you have finished listening. Turn the JiSS-250i off and  
unplug the AUX IN jack.  
CARE AND MAINTENANCE  
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.  
2. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent  
lamps or motors.  
3. For better Display clarity, avoid operating the unit under direct sunlight or in strong room  
illumination.  
4. Unplug the unit from the electrical power outlet immediately in case of malfunction.  
6
 
TROUBLESHOOTING GUIDE  
Should you experience any difficulties in the use of this player please refer to the following chart or  
call 1 800 777 5331 for Product Service and Support.  
Symptom  
Possible Problem  
Solution  
Cannot dock iPod Using a wrong iPod adaptor Make sure the adaptor properly fits for your iPod.  
properly  
iPod is not installed  
properly.  
Remove your iPod from the dock and check for any  
obstruction on the connectors in the dock and on your  
iPod, then reseat it in the dock.  
iPod does not  
respond to the unit. properly.  
iPod is not installed  
Remove your iPod from the dock and check for any  
obstruction on the connectors in the dock and on your  
iPod, then reseat in the dock.  
Your iPod software is too  
Update software on your iPod. For details, please visit  
Unplug the audio connection cable.  
old  
No sound when AUX IN Jack is plugged  
iPod plays  
No sound from  
speaker in AUX  
mode  
Input source is low  
Increase the volume level on the audio source device.  
Switch on the power of the external source.  
Power to external source  
(MP3, Laptop etc) not  
switched on.  
No sound when  
played in the AUX  
Mode  
Master Volume is at  
minimum.  
Adjust the master volume  
Too much distortion  
Batteries are low. change  
the New Batteries  
Replace all batteries by fresh ones.  
SERVICE  
Please refer to the instructions on the enclosed warranty card for returning your unit for service.  
When returning the unit, please remove any batteries to prevent damage to the unit in transit and/or  
from possible battery leakage. Please note that we are not responsible for batteries returned with  
the unit or for the cost of replacement of batteries.  
Distributed by:  
Spectra Merchandising International, Inc.  
4230 North Normandy Avenue  
Chicago IL 60634, U.S.A.  
Please have model number ready, for Customer service, call 1-800-777-5331  
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.  
iPhone is a trademark of Apple Inc.  
"Made for iPod" means that an electronic accessory has been designed to connect specifically to  
iPod and has been certified by the developer to meet Apple performance standards.  
"Works With iPhone" means that an electronic accessory has been designed to connect specifically  
to iPhone and has been certified by the developer to meet Apple performance standards.  
Apple is not responsible for the operation of this devise or its compliance with safety and regulatory  
standards.  
Printed in China  
7
 

Indesit Dishwasher IDE 750 User Manual
Ingersoll Rand Automobile Parts LM2350E X User Manual
Intel Computer Hardware SASMF8I User Manual
Jacuzzi Flat Panel Television LCD Series User Manual
JVC Flat Panel Television 1EMN24939 User Manual
Kenmore Air Conditioner 25371124 User Manual
Kenmore Blender 10090001 User Manual
Kenwood Car Video System Z910DVD[K] User Manual
Kenwood Stereo Receiver VRS 6100 User Manual
KitchenAid Refrigerator NL240V User Manual