Infinity Car Speaker 402CS User Manual

kappa series  
40.2cs, 50.2cs,  
60.2cs & 652.2cs  
instructions  
Thank you  
for purchasing an Infinity Kappa Series 2-Way  
Com ponent System . Weve organized this m anual to m ake your instal-  
lation as sim ple and trouble-free as possible. Please read it thoroughly  
before proceeding. Rem em ber to keep your sales receipt with this  
m anual in a safe place so both are available for future reference.  
 
WIRE CODES  
WOOFER INSTALLATION  
TWEETER INSTALLATION  
Figure 6  
3
ROTATE TO AIM  
ANGLED TWEETER  
TO LISTENER  
Tweeter level  
+3dB  
Tweeter level  
0dB  
Figure 3  
Figure 4  
+
1
SLIDE UP OR DOWN  
TO ADJUST TWEETER  
ANGLE  
1
KX00  
2
+3dB  
+0db  
2
TIGHTEN NUT AND  
WASHER TO LOCK  
THE ANGLE SETTINGS  
+
IN  
-
+
W
-
+
T
-
Fasten the m idrange through the plastic grille  
tray with the screws and clips provided.  
Press the m etal m esh in place in the tray.  
Mounting the tweeter using the I-Mount  
surface-m ounting kit.  
Aim the tweeter at the listening position by  
sliding the stud in the groove on the back of the  
tweeter cup and rotating the entire assem bly in  
the m ounting surface. Lock the tweeter in place  
using the sm all retaining nut and the large plastic  
m ounting nut.  
To tweeter  
To amplifier  
speaker output  
To woofer  
Figure 5  
Figure 2  
Connect the speakers and am plifier  
to the crossover as shown.  
1
2
Mounting the tweeter using the I-Mount  
flush-m ounting kit.  
- 3 -  
 
A NOTE ON POWER HANDLING  
SPECIFICATIONS  
The speakers used in Kappa Series 2-Way  
40.2cs  
60.2cs  
Com ponent System s are designed to produce rea-  
sonable volum e levels with little am plifier power.  
However, the addition of an am plifier to drive  
your speakers and a subwoofer will enhance the  
dynam ic range of your system , and help over-  
com e the am bient noise in a m oving vehicle.  
Kappa speakers are designed to handle the power  
of a dedicated am plifier driven at or below its  
rated power. If an am plifier is driven far above its  
rated power, the output signal will clip,and the  
additional power present in a clipped signal can  
dam age any speaker. Distorted or fuzzysound  
from your speakers is an indication that the am pli-  
fier has exceeded its rated power, and you should  
reduce the volum e level.  
Type:  
4" 2-Way System  
4 Ohm s  
75W RMS, 300W peak  
Type:  
6-1/2" 2-Way System  
4 Ohm s  
90W RMS, 360W peak  
Speaker Im pedance:  
Power Handling:  
Frequency  
Response (±3dB):  
Sensitivity:  
Crossover Frequency:  
Mounting Depth,  
Drop-in Midrange:  
Cutout Diam eter  
Midrange:  
Speaker Im pedance:  
Power Handling:  
Frequency  
Response (±3dB):  
Sensitivity:  
Crossover Frequency:  
Mounting Depth, Drop-in: 2-7/16" (62m m )  
Cutout Diam eter: 5-1/8" (131m m )  
80Hz ~ 21kHz  
89dB  
3.5kHz  
50Hz ~ 21kHz  
89dB  
3.5kHz  
1-13/16" (47m m )  
3-3/4" (96m m )  
Cutout Diam eter Tweeter: 1-3/4" (45m m )  
Cutout Diam eter Tweeter: 1-3/4" (45m m )  
652.2cs  
Type:  
165m m 2-Way System  
4 Ohm s  
90W RMS, 360W peak  
50.2cs  
Type:  
Speaker Im pedance:  
Power Handling:  
Frequency  
Response (±3dB):  
Sensitivity:  
5-1/4" 2-Way System  
4 Ohm s  
85W RMS, 340W peak  
Speaker Im pedance:  
Power Handling:  
Frequency  
Response (±3dB):  
Sensitivity:  
50Hz ~ 21kHz  
89dB  
3.5kHz  
GENERAL CARE  
59Hz ~ 21kHz  
89dB  
3.5kHz  
Crossover Frequency:  
Mounting Depth, Drop-in: 2-1/2" (64m m )  
Cutout Diam eter: 5-11/16" (145m m )  
Cutout Diam eter Tweeter:1-3/4" (45m m )  
The loudspeaker grilles m ay be cleaned with a  
slightly dam p cloth. Do not use any cleaners or  
solvents on the grilles or the speaker cones.  
Crossover Frequency:  
Mounting Depth, Drop-in: 2-3/8" (61m m )  
Cutout Diam eter: 4-13/16" (123m m )  
Cutout Diam eter Tweeter: 1-3/4" (45m m )  
DECLARATION OF CONFORMITY  
We, Harman Consumer International  
2, route de Tours  
72500 Chateau-du-Loir  
France  
declare in own responsibility, that the products described in this owners manual are in compliance with technical standards:  
EN 50081-1:1992  
Infinity System s, Inc. 250 Crossways Park Drive  
Lutz Uphoff  
EN 50082-1:1992  
Woodbury, NY 11797 USA (800) 553-3332 FAX (516) 682-3523  
Harman Consumer International 12/99  
P/N:INFKAPCSOM  
 

Ingersoll Rand Impact Driver 3955 Series User Manual
JAMO Speaker A804 User Manual
Jenn Air Washer Dryer LSE2704W User Manual
JVC Car Stereo System KD AHD65 User Manual
Keating Of Chicago Fryer APR 96 User Manual
King Canada Satellite TV System 9818 RJ User Manual
KitchenAid Cell Phone KGRS807S User Manual
Kodak Film Camera TIB5200 User Manual
Kolcraft Stroller S64 R2 User Manual
Kompernass Switch KH 2346 User Manual